User Manual

Caution: Never remove the marker internals while the air
tank is attached to the marker. Remove the paintballs,
the loader, and the air tank before performing
maintenance.loader, and the air tank before performing
maintenance.
The primary method of adjusting the velocity is through
the rear velocity adjuster, which is located at the back of
the marker.
Turning the Velocity Adjuster (VA01) clockwise will
increase the velocity (FPS).
Turning the Velocity Adjuster (VA01) counter clockwise
will decrease the velocity (FPS).
Caution: Over adjusting the Velocity Adjuster (VA01) may
cause it to derail and it may strip the threads on the
]Velocity Adjuster and End Cap (EC02).
Adjusting the regulator will change the amount of
pressure entering the marker. Regulators are preset for
optimum performance from the factory and most
adjustments should be made through the rear velocity
adjuster.
Turning the Rock Steady Seat (RSS2) clockwise will
decrease the input pressure from the regulator.
Turning the Rock Steady Seat (RSS2) counter clockwise
will increase the input pressure form the regulator.
Note: Regulator Adjustments should be made at 1/4
turn at a time. The marker should then be red before
continuing.
VELOCITY ADJUSTMENTS
REGULATOR ADJUSTMENTS
BASIC MAINTENANCE