Installation guide

KB351RT User Guide
6
2.3 Ssynchronization of the Receiver & Keyboard
The RF Wireless Keyboard is equipped with the newest RF radio technology
allowing for easy, auto-channel, synchronisation.
• Place the keyboard and receiver dongle close to
each other when synchronizing. Ideally, within
30cm. But within 1m, is acceptable.
• In contrast to conventional or older wireless
keyboards on the market, you will only need to
press the PAIRING key on the back side 1 time, in
order to start the synchronisation signal to the USB
receiver.
• Synchronisation can take up to 10 seconds and is
signalled by the flashing pairing LED (most left LED
on the front of the keyboard), which will turn off after
a successful pairing.
The keyboard receiver dongle is now synchronised.
• Check functionality of the keyboard to confirm.
Note:
One benefit of this new radio technology is the provision of a large number of
possible independent radio channels (16 channels *2
16
Bit = 1.048.576
possible IDs). This will ensure a trouble-free and secured operation of several
wireless keyboards in one room, with a range of 10m.
In the unlikely event the keyboard does not work even after synchronization, you
can try the following options to resolve this problem:
• If your USB receiver is attached to a USB hub, please install it directly
• During synchronisation, the keyboard should be located close to the USB
receiver to ensure a successful paring. Also ensure that the immediate vicinity
is ideal for radio transmission. Avoid interferences due to metal surfaces or
other sources of magnetic / wireless interferences.
to the
USB connector of your notebook or desktop.
• Ensure you are using new batteries. When in doubt, change the batteries as a
precaution, then resume resynchronisation.