User's Manual

Azalea MST200 Quick Installation Guide

6 Grounding of MST200

The grounding of MST200 is to protect MST200 from electrostatic damage, there is

grounding terminal on the enclosure of MST200.

Tools needed: Paper knife, Pliers, Crimping Pliers, and Cross Screwdriver.

The procedure of grounding is as:

1． Put naked side of grounding wire into the copper ring, and press it firmly by

Crimping Pliers;

2． Unmount the screw of in the grounding terminal.

3． Put the copper ring into the grounding terminal.

4． Fasten the screw by Cross Screwdriver;

5． Connect the other side of grounding wire with grounding bar;

6． Daub butter on both side of grounding wire

Never skip grounding in the MST200 installation, and it must be finished

before powering up MST200.The residence of grounding wire must be less than 5

ohm.

Figure 13 Grounding of MST200