User's Manual

Azalea MST200 Quick Installation Guide
Copyright 2008 Azalea Networks
15
4 Antenna Installation
MST200 uses two types of antennas: built-in antenna and external antenna.
The built-in antenna has already been installed inside the plastic enclosure at the front of
MST200. The built-in antenna works at the same frequency band as the corresponding
MST200 and is configured to the factory setting (See figure below).
Figure 6 MST200 Front Side
The external antenna port is remained at the bottom of MST200 for users to freely choose
gain or types of antennas. If users choose the external antenna port in software
configuration, the antenna must be connected in advance or effective load.
Figure 7 MST200 Bottom Side
When installing MST200 (details refer to Chapter 5), the MST200 should, according to
the network design, face the direction where the antenna of MSR routers points to.
Unless the elevation needs to be adjusted, usually the MST200 is in horizontal position.