User's Manual

AZALEA MSR4000 INSTALLATION GUIDE

Figure 8 Configuring the portal node, step 4

After the last step of confirming the reboot is performed, the web interface would stop responding

for a few seconds while the router reboots itself. Note that since the quick setup changes the IP

address of the Ethernet 0 port on the router, you may need to re-open the web interface using the

new IP address if you were using Ethernet 0 to connect to the router.

Example Configuration 2: Point node

The following figures show how the example point node can be configured by answering the

questions on each screen.

Figure 9 Configuring the point node, step 1