User's Manual

AZALEA MSR4000 INSTALLATION GUIDE

8 Ethernet Cable Installation

Ethernet cable connects MSR4000 mesh network to wire network. Ethernet cable is needed, only

when MSR4000 used as gateway. The performance of network cable will degrade seriously with

length longer than 100 meters. So in MSR nodes planning, it is better to choose access point to

wire network within 100 meters.

The process of Ethernet cable installation

1． Unscrew the protective cap on the Ethernet enclosure.

2． Plug Ethernet cable RJ45 head to MSR4000 Ethernet interface.

3． Water proof the connection by wiring insulation Adhesive Tape and PVC insulation type;

9 Power Cord Installation

MSR4000 use 100-240V AC as power, the power interface is

on the left bottom of MSR4000. Power cable should be the

last step of installation.

Tools: Diagonal Pliers，paper knife

The procedure of power cable installation:

1． Point the female power plug to MSR4000 power port

2． lug the power cable firmly to the port, further tighten the connection by turning the coupling

ring, (which is already attached to the plug) clockwise;

3． Water proof the connection by wiring insulation Adhesive Tape and PVC insulation type;

4． Secure the power cable follow to the pole with strap, but don’t make it too tight

5． The other side of power cable plug use normal 3 male pin connection to power supply.

Installation of power cable must be done by experienced technician. Please read

the installation manual carefully before installation.

Before finally power up MSR4000, make sure grounding is done correctly