User's Manual
Table Of Contents
- 1 MSR4K44S Quick Installation Guide
- 2 Abstract
- 2.1 Function Introduction
- 2.2 Appearance and Interfaces
- 2.3 Operating Range
- 2.4 Environmental Rating
- 2.5 LED Panel
- 2.6 Ethernet Cable
- 2.7 Console Cable
- 2.8 Power Cable
- 2.9 Screws
- 3 Installation Preparation
- 4 Antenna Installation
- 5 MSR4K44S Installation
- 6 Lightning Protection Installation
- 7 Feeder Installation
- 8 Ethernet Cable Installation
- Power Cord Installation
- 10 Completed Installation
- 11 Administrating the MSR4K44S
- Appendix
AZALEA MSR4K44S INSTALLATION GUIDE
COPYRIGHT 2007 AZALEA NETWORKS
31
Figure 6 Configuring the portal node, step 4
After the last step of confirming the reboot is performed, the web interface would stop
responding for a few seconds while the router reboots itself. Note that since the
quick setup changes the IP address of the Ethernet 0 port on the router, you may
need to re-open the web interface using the new IP address if you were using
Ethernet 0 to connect to the router.
Example Configuration 2: Point node
The following figures show how the example point node can be configured by
answering the questions on each screen.
Figure 7 Configuring the point node, step 1