User's Manual

Table Of Contents

AZALEA MSR4K44S INSTALLATION GUIDE

The process of installing MSR4K44S on a wall is as:

1． Put the MSR4K44S bracket against the wall and mark

the 4 position of nut holes;

2． Drilling on the 4 mark positions;

3． Hit expansion bolts into wall;

4． Put MSR4K44S bracket on the expansion bolts;

5． Use the 2 MSR fastening bolt to fix MSR onto the

bracket

6． Use shield fastening bolts to install the solar shield

onto MSR4K44S

5.3 Grounding of MSR4K44S

The grounding of MSR4K44S is to protect MSR4K44S from electrostatic damage,

there is grounding terminal on the enclosure of MSR4K44S.

Tools needed: Paper knife, Pliers, Crimping Pliers, and Cross Screwdriver.

The procedure of grounding is as:

1． Put naked side of grounding wire into the copper ring, and press it firmly by

Crimping Pliers;

2． Unmount the screw of in the grounding terminal.

3． Put the copper ring into the grounding terminal.

4． Fasten the screw by Cross Screwdriver;

5． Connect the other side of grounding wire with grounding bar;

6． Daub butter on both side of grounding wire

Never skip grounding in the MSR4K44S installation, and it must be finished

before powering up MSR4K44S.The residence of grounding wire must be less than 5

ohm.

5.4 Assembling Solar Shield

Secure screws through the holes on the corner of shield to MSR4K44S.