Installation Guide

AZALEA MSR4000 INSTALLATION GUIDE

take extreme care not to come into contact with such electrical circuits, as they can cause

serious injury or death.

Grounding Warning

Please always remember to protect your MSR4000 system by installation of

grounding lines. The ground connection must be complete before connecting power to the

MSR4000 enclosure. The requirement of grounding is to make sure the resistance must be

less than 5 ohm between the ground termination point to grounding tier.

Power Installation Warning

The installation of power switch must be performed by a trained professional

technician.

The power switch is not supplied with the MSR4000. The power cord must be assembled

by a professional installer, and the final assembly must comply with related requirements.

Solar Irradiation and high Temperature Protection

Please pay attention of sunlight which will make the working temperature of

MSR4000 higher then the specification

MR4000 would be located under sunlight. The solar shield which provided in Azalea

standard package should be installed to outdoor MSR4000. The Azalea Warrantee policy

does not cover those outdoor products which Solar shield is not installed for it. Please

contact Azalea technical support engineers for detail information.

RF Device Protection

Before powering up MSR4000, RF port must be connected to valid load,

powering up with unloaded RF port is not allowed. Improper operation with power can

cause damage of RF module. Azalea will not take any responsibility for such damage.