Installation Guide

AZALEA MSR4000 INSTALLATION GUIDE

Figure 6 Configuring the portal node, step 4

After the last step of confirming the reboot is performed, the web interface would stop

responding for a few seconds while the router reboots itself. Note that since the

quick setup changes the IP address of the Ethernet 0 port on the router, you may

need to re-open the web interface using the new IP address if you were using

Ethernet 0 to connect to the router.

Example Configuration 2: Point node

The following figures show how the example point node can be configured by

answering the questions on each screen.

Figure 7 Configuring the point node, step 1