Installation Guide

AZALEA MSR4000 INSTALLATION GUIDE

8 Ethernet Cable Installation

Ethernet cable connects MSR4000 mesh network to wire network. Ethernet cable is

needed, only when MSR4000 used as gateway. The performance of network cable

will degrade seriously with length longer than 100 meters. So in MSR nodes

planning, it is better to choose access point to wire network within 100 meters.

The process of Ethernet cable installation

1． Unscrew the protective cap on the Ethernet enclosure.

2． plug Ethernet cable RJ45 head to MSR4000 Ethernet interface.

3． Water proof the connection by wiring insulation Adhesive Tape and PVC

insulation type;

9 Power Cord Installation

MSR4000 use 110-220V AC as power, the power interface is on the left bottom of

MSR4000. Power cable should be the last step of installation.

Tools: Diagonal Pliers，paper knife

The procedure of power cable installation:

1． Point the female power plug to MSR4000 power port

2． lug the power cable firmly to the port, further tighten the connection by turning

the coupling ring, (which is already attached to the plug) clockwise;

3． Water proof the connection by wiring insulation Adhesive Tape and PVC

insulation type;

4． Secure the power cable follow to the pole with strap, but don’t make it too tight

5． The other side of power cable plug use normal 3 male pin connection to power

supply.

Installation of power cable must be done by experienced technician. Please

read the installation manual carefully before installation.

Before finally power up MSR4000, make sure grounding is done correctly