Installation Guide

AZALEA MSR4000 INSTALLATION GUIDE

The process of installing MSR4000 on a wall is as:

1． Put the MSR4000 bracket against the wall and mark

the 4 position of nut holes;

2． Drilling on the 4 mark positions;

3． Hit expansion bolts into wall;

4． Put MSR4000 bracket on the expansion bolts;

5． Use the 2 MSR fastening bolt to fix MSR onto the

bracket

6． Use shield fastening bolts to install the solar shield

onto MSR4000

5.3 Grounding of MSR4000

The grounding of MSR4000 is to protect MSR4000 from electrostatic damage, there

is grounding terminal on the enclosure of MSR4000.

Tools needed: Paper knife, Pliers, Crimping Pliers, and Cross Screwdriver.

The procedure of grounding is as:

1． Put naked side of grounding wire into the copper ring, and press it firmly by

Crimping Pliers;

2． Unmount the screw of in the grounding terminal.

3． Put the copper ring into the grounding terminal.

4． Fasten the screw by Cross Screwdriver;

5． Connect the other side of grounding wire with grounding bar;

6． Daub butter on both side of grounding wire

Never skip grounding in the MSR4000 installation, and it must be finished

before powering up MSR4000.The residence of grounding wire must be less than 5

ohm.

5.4 Assembling Solar Shield

Secure screws through the holes on the corner of shield to MSR4000.