Installation Guide

AZALEA MSR4000 INSTALLATION GUIDE

z Antenna Installation

Tools: Spanners size 10

1． The height of antenna must follow the

requirement in desgin documentation ( enough

isolation should be secured between antennas,

vertical isolution is much better than horizental

isolation);

2． Put antenna to pole by U-bolt, start from upper

U-bolt then down one;

3． Fix antenna on bracket, don’t strengthen the nut

too tight because the antenna azimuth will be

adjusted.

z Azimuth and Tilting Adjustment

Tools needed: Spanner, Compass, and Inclinometer.

Adjusting azimuth:

1． To measure the azimuth by compass;

2． Compare the difference between the actual

azimuth with design value;

3． Slightly adjust azimuth to design value;

4． Measure the azimuth again to secure the

difference less than 5 degree;

5． Fix the down U-bolt by screwdriver.

Adjusting down tilt angle:

6． Measure the down tilt angle by angle inclinometer;

7． Compare the difference between actual figure with

design value;

8． Slightly adjust the downtilt angle by stretching or

shrink the up-bracket.

9． Measure the down-tilt angle again to secure the

difference between actual downtilt angle and actual

one less than 0.5 degree;

10． Fasten nuts in upper bracket to complete the

installation of directional antenna.