User's Manual

AZALEA MSR2000 INSTALLATION GUIDE

8 Ethernet Cable Installation

At least one MSR2000 should be connected to the wired network to function as the gateway for traffic

between the wired network and the wireless mesh network. Locate the nine pin Ethernet cable and uncap

the connector protector on the MSR2000. Connect the nine pin Ethernet cable and turn it clockwise to

secure it to the MSR2000 Ethernet port, then use PVC insulating tape to weather proof and secure the

Ethernet cable to the port, as shown in the Figure 8.

Figure 8 Connect Ethernet cable to Ethernet port

9 Power Cord Installation

Installation of power source must be done by trained electrician.

MSR2000 must be grounded before power up.

The antennas should be setup before connecting the power source to MSR2000. Please refer to the

respective antenna installation guide for further instructions. The power terminal is located on the left side

of the MSR2000. Connect the three pin power cable and turn it clockwise to fasten it to the power terminal,

as shown in Figure 9. Use PVC insulating tape to weather proof and secure the power cable to the power

terminal. Finally, secure the power cable, grounding cable, and the Ethernet cable to the mast using cable

tie.

Figure 9 Connect the power cable to MSR2000