User's Manual

AZALEA MSR2000 INSTALLATION GUIDE

5.2 Install MSR2000 on Mast

Figure 4 Install the anchor ear

Figure 5 Mounting the MSR2000 system

5.3 Mounting MSR2000 onto wall

The MSR2000 can also be mounted onto a wall instead of a pole, by following these instructions. First, place

the installation bracket against the wall to mark out the four positions to drill for the bolts. Proceed to drill

into the four marked positions and screw in the expansion bolts. Mount the MSR2000 and the installation

bracket onto the expansion bolts. Fasten the nuts to secure the MSR2000 to the wall as shown in Figure 6.

Figure 6 Wall mounted MSR2000

5.4 Grounding of MSR2000

MSR2000 must be grounded before power up. Grounding wire resistance must be less than 5 ohm. The

MSR2000 must be grounded to prevent electrostatic damage. The grounding terminal is at the side of the

MSR2000. The grounding cable is to be attached to the grounding terminal on the MSR2000. First, secure the

exposed end of the grounding cable to the copper ring by running the exposed wire through the copper ring

and ensuring it is tightly wound. Next, on the MSR2000 grounding terminal, loosen the screw and place the

copper ring through the grounding terminal, then refasten the screw. Connect the other end of the grounding