User's Manual Part 3

〓MSR Series Quick Start Guide, AOS-v2.0〓

Chapter 3 Performing the Quick Start

There are two methods of performing the quick start configuration: using the Quick

Setup Wizard provided by MSR series’ Web-based Management Interface (WMI), or

using the setup command of the router’s Command Line Interface (CLI). Azalea

recommends using the Quick Setup Wizard which is accessible from most modern

internet browsers such as Internet Explorer. The Quick Setup Wizard simplifies the

initial configuration of the router into answering a few simple questions.

Configuring nodes with the Quick Setup Wizard

The basic software requirement for the web-interface is:

• Web Browser： Internet Explorer 5.5 and above with Javascript enabled

• Optimal Resolution：1024 X 768 and above

Accessing the Quick Setup Wizard

To access the WMI’s Quick Setup Wizard, input the IP address of that router and the

port:9080 in the address field of your web browser. On an un-configured MSR series

router, you can connect a client PC to the router’s Ethernet 0 port and use the port’s

default IP address of 192.168.0.1 to connect. A pop-up dialog box would appear and

request a username and password (see Figure 2) The default username is ‘root’ and

password is ‘public’. After the successful authentication, the home page for WMI would

appear (see Figure 3)

Figure 2 Logging into Web Management Interface (WMI)