Use and Care Manual

7
ASSEMBLY INSTRUCTIONS
Hardware Used
4
5-1
4. Attach post to cylinder housing using the reinforced
ring (NN), four M6 X 10 bolts (DD) and small flat washers
Φ6 (EE). Fasten them and cover with the deck ring (OO).
5. Table Installation.
5-1. Revised the table (D). Attached the table connector
(E) to the table, secure them with four M5X 8 screws
(CC).
5-2. Turn the handle of connector in a clockwise
direction, put the hole in the middle of the table through
the pole. Turn the table in a clockwise direction to tighten
and in a counter-clockwise direction to loosen.
NN
OO
EE
NN
Small flat washer Φ6
x 4
x 1
Reinforced ring
OO
x 1
Deck ring
D
E
CC
5-2
DD
Bolt M6 X 10
x 4
Tighten
Loosen
CC
Screw M5 X 8
x 4
Note: If table can not be tighten, turn the handle of
connector in a counter-clockwise direction a little, then turn
the table in a clockwise direction to tighen.