Use and Care Manual

6
ASSEMBLY INSTRUCTIONS
Hardware Used
CC
2
3
TT
2. Attach cylinder housing (G) to base. Attach cylinder
housing loosely to base with four M5 X 8 screws (CC).
3. Attach post (H) to cylinder housing top. Open the door,
put post through the hole on the top of cylinder housing.
DD
Screw M5 X 8
x 4
H
G
CC
Hardware Used
AA
BB
1
1. Line up holes on the bracket of wheel assembly (J)
with the corresponding holes on base (I), then insert
M8 x 16 mm bolts (BB) through holes. Hand tighten with
M8 flange nuts (AA). Be sure the wheel assembly (J) is
parallel to the base (I).
Note: To improve stability, the preassembled bucket (K)
can be filled with sand (not included).
x 2
M8 x 16 mm Bolts
M8 Flange Nut
x 2
I
K
AA
BB
J
Fill sand