Use and Care Manual

11
ASSEMBLY INSTRUCTIONS
11
12
12. Carefully lean the assembly and attach
reflector (A) to mesh (B) with studs (CC),
small flat washers (BB) on either side of
reflector (A) and then wing nuts (AA).
Gently return the assembly to the upright
position.
Hardware Used
AA
BB
x 3
x 6
Small Flat
Washer
Wing Nut
Hardware Used
DD
FF
x 3
x 3
x 1
Fixing Bracket
LL
Phillips
Screwdriver
M5 x 12 mm Screw
F B
DD
FF
A
AA
CC
BB
CC
x 3
Stud
11. Assebmly the protective guard and mesh
Insert the hooks of protective guard (F) to the
holes of upper supports (E).
Put the mesh (B) on the top plate (D). Make sure
the screw holes align the holes of top plate (D).
Use Phillips screwdriver (LL) to secure the
mesh (B) and protective guard (F) to the top
plate (D) with M5 x 12 mm screws (DD) and
fixing bracket (FF).