ALO 030 MKII 30 Watt DMX LED scanner User manual
Safety instructions WARNING! Always keep this device away from moisture and rain! Hazardous electrical shocks may occur! WARNING! Only connect this device to a matching power outlet. This device is intended to work on a specified AC currency. Connecting this device to power outlets with other voltages may result in permanent damage and possible hazardous situations, such as fire or electrical shocks! WARNING! Be careful with every operation of this device.
- Only handle the power cord by its connectors. Never pull the cable to remove a connector from its socket, as this could lead to damage and electrical shocks. - Always operate this device with a stable AC current. - Always operate this device with the AC ground wire connected to the electrical system's ground. - Never use other types of cables than specified in the manual, do not use defective or bad functioning cables.
Box contents Box contents 1x ALO 030 fixture 1x power cable Unit and accessory inspection - Always use the supplied power cable to connect the unit to a power supply. If the cable appears broken or has visible damage, do not use it. - If the unit is not going to be used for a longer period of time, disconnect it from the power supply and store it in a dust-free environment. - Always check the unit for possible damage before use.
Device overview 1 7 2 9 10 3 4 6 5 8 11 12 4 1. Moving mirror 2. Beam output with manual focus 3. Standing/hanging adjustable bracket 4. Ventilation slots 5. IEC Power inlet with integrated fuse holder 6. IEC Power outlet (used to link several fixtures) 7. Control panel display with MENU, UP and DOWN buttons 8. Sound sensitivity potentiometer 9. Safety eye, for optional safety cable 10. Built-in microphone for sound active mode 11. DMX input (3P XLR) 12.
Setting up the unit To activate the unit, connect the included power supply with the unit and a suitable 230V, 50 Hz power outlet. The unit will activate directly after it is plugged in to a wall outlet or other power source. Give the scanner time to calibrate the stepping motors, which are used to determine the position of the mirror. You may hear and see some shaking, which is normal. The stepping motors use an end point to determine the beginning and end of their movement.
DMX-signal is received, a blinking red dot on the display is active.
232 239 240 248 247 255 Shutter open (235 = reset function when the value is selected for 3-5 seconds) Random strobe Shutter open Channel 6: Dimmer: 0-255 (variable) Channel 7: Movement macros: Start value 0 8 26 44 62 80 98 116 134 152 170 188 206 224 242 End value 7 25 43 61 79 97 115 133 151 169 187 205 223 241 255 Function No function Movement macro 1 Movement macro 2 Movement macro 3 Movement macro 4 Movement macro 5 Movement macro 6 Movement macro 7 Movement macro 8 Movement macro 9 Movement m
Technical specifications - Compact scanner with LED light source LED module: 1x 30W LED chip 8 DMX-channels 3-pin XLR in- and output Music controlled mode with internal microphone Microphone sensitivity adjustable Maximum flash rate: 18 Hz Maximum ambient temperature: 45 degrees Celsius Maximum distance from flammable surfaces: 0.5m Power consumption: 50W max.
