Specifications

08
The Axxis HS Digital Label Finisher is shipped assembled, however it must be properly unpacked,
installed, and set up to run prior to operating. This manual will guide you through each of these
processes.
For your own safety, read this instruction manual before operating the equipment.
Knowledge of the machine’s components and specic hazards will minimize the possibility of
accidents and injury.
Wear proper clothing. Do not wear loose clothing, neckties, necklaces, or jewelry, which may be
caught in moving parts. Shoulder length hair and longer should be pulled back, and secured at all
times to prevent catching in equipment.
Keep your work area clean and well-lit to prevent tripping or accidentally placing body parts in
danger.
An Emergency Stop (E-Stop) push button located on the front of the machine, on the side of the
control panel. You can use this switch any time to ensure that none of the motors will move. NOTE:
The E-Stop stops all motors. If the E-Stop switch is depressed then no motors on the nisher will
move. To power the system back on, rotate the E-Stop in the direction of the arrows.
1.0 Introduction
1.0.1 Safety