Specifications

28
1.4.5 Biweekly Cleaning (continued)
1.4.6 Monthly Cleaning
1.4.7 Annual Cleaning
Rubber Nip Rollers
Clean using rubber roller cleaner and a soft cloth. Adhesive build-up may be removed using the
roller cleaner and gently scraping the surface.
NOTE: Usearubberrollercleanersuchasthetypesoldinofcesupplystores.Avoidusing
isopropyl or denatured alcohol on rubber parts. Alcohol will dry and harden the rubber surfaces.
Metal Rollers and Guides
Inspect for dust or adhesive build up. Remove dust using a soft cloth. Adhesive build-up may be
removed using a small amount of Isopropyl alcohol or citrus-based adhesive remover and gentle
scraping with a ngernail, brass brush, or toothbrush.
Clean the outer surface of the machine. If necessary, a mild cleaning solution (such as mild soap
and water) on a damp cloth can be used to gently wipe painted surfaces clean.
Do not use abrasive cleaners. Abrasive cleaners will cause the paint to blister.
Use a solution of mild soap and water.
Observe static discharge safety procedures that may damage sensitive electronic components.
Wear a grounding strap connected to earth ground. Wear safety glasses to protect eyes. Etc.
ALWAYS disconnect the power source while cleaning any part of the machine.
Keep power source disconnected until the cleaning process is completed.
1. Open rear cover by removing 6 screws around base of the cover (use 3mm Allen Wrench)
2. Use compressed air to remove dust and debris.
3.Inspecttheinternalcircuitboardassembliesandcleanaccumulateddustasnecessary.
4. Make certain that the boards and any connectors are well seated.
5.Inspectbeltsforanysignsofwear,suchaswornormissingteeth.Closecovertooriginallocation
and reinstall screws.