Specifications

27
1.4.4 Cleaning the Axxis HS Digital Finisher
1.4.5 Biweekly Cleaning
The regularity with which the cutter needs to be cleaned is dependent on the usage, as well as the
climate and contaminants in the cutter’s environment. It is recommended that the following cleaning
steps be done at least as often as indicated for each procedure.
ALWAYS disconnect the power source while cleaning any part of the machine.
Keep power source disconnected until the cleaning process is completed.
Items needed for cleaning:
● Small bristle brush (toothbrush), soft cloths, rubber roller cleaner, mild solution of soap and water.
Grit Rollers
The grit roller, pinch wheels, and the nips move the media through the nisher. Keeping the grit
rollers clean allows the cutter to hold the media properly. Clean the grit rollers with a stiff bristled
brush (e.g. toothbrush) to remove any media particles built up during cutting. Brass “toothbrushes”
can be used, and are available at either auto parts stores or building supply stores such as Home
Depot.
1. Disconnect power from machine
2. Disengage rubber rollers and pinch wheels from the grit rollers (handles in up position)
3. Do not use a steel wire bristle brush. A steel wire brush will damage the Grit Roller. Brass brushes
are safe to use.
4. Brush the surface of the grit wheel while turning the grit roller by hand so the entire surface of the
grit wheel is cleaned.
Pinch Wheels
Wipe media-related dust from the set of polyurethane pinch wheels using a soft cloth. To clean
adhesive off the pinch wheels, simply use a soft cloth and rubber roller cleaner.