Specifications
26
1.4.3 Changing the Cut Strip
The Cut Strip should be replaced when the cut quality deteriorates, or when grooves/divots are
observed
1. Move the knife carriage to the gear side of the cutter.
2. Clean any debris from the cut strip groove before removing the existing strip.
3. Use the Cut Strip Removal Tool, found in the white accessory box, to remove the worn strip.
a) Place the hooked end of the tool under one end of the Cut Strip
b) Pull up gently until there is enough material to pull up by hand.
Cut Strips are held in place with light easy to remove adhesive.
4. Clean any debris from the groove and inspect before installing the new Cut Strip.
5. Peel the backing off the new cut strip to expose adhesive and place in groove.
6. Press down rmly to ensure proper seating.
NOTE: ItisimportanttoinstalltheCutStripfullyandevenly,otherwisematerial“cutthrough”may
occur in some sections across the cutter.
Different cut strips are available from the http://allendatagraph.com online store.