Specifications

24
1.4.0 Maintenance & Consumables
1.4.1 Fuses
Maintenance performed on this machine will require the tools that are shipped in the accessory kit
that is received with the machine. Replacement parts and tools may be ordered using our online
store at www.allendatagraph.com.
There are two (2) spare fuses provided with the nisher. If you have 110v AC use one 5-amp fuse. If
you have 220v AC use two 2.5-amp fuses (remove the shorting clip to use two fuses).
Replacing a Fuse
1. Disconnect the AC power cord from the fuse block on the
power input end panel.
2. Open the fuse block cover with a small at screwdriver
and pull out the fuse block.
3. Remove the spent fuse and replace with a new one.
4. Orient the fuse block so that the desired voltage
appears in the fuse block cover.
5. Close the fuse block cover and verify
that the desired voltage is showing.