Specifications

23
1.3.0 Using Accessories
1.3.1 Weed Bar
The Weed Bar is used when cutting medium to larger sized shapes. The bar is spring-loaded on
one end and can be installed or removed without using any tools.
To remove: Push the bar toward the gear side of the machine and lift it out from the operator end
to release it.
To install:
1. Take the o-rings from the accessory kit and install them onto the weed bar.
2. Insert the bar (spring end rst) into its mounting hole on the gear side of the machine.
3. Push the bar toward the gear side of the machine while aligning it with the mounting hole on
the operator side.
4. Insert end of the bar into hole and release so that it springs into place.
5. Slide o-rings into place so that they will roll over the labels or cut lines.