Specifications

c) If material moved to gear side then move material towards gear side. To adjust hold end

of material before releasing output nip black lock lever, this way the accumulator will not

pull material backwards and drop to bottom. Now adjust material to gear side desired

amount to square. Repeat webbing test.

5. When straight (within 1/32”), adjust pinch wheels so that each wheel is approximately 0.5” from

edge of material, then lock down the pinch wheels by lowering the pinch handle and tighten the

web roller guides (black thin donuts).

Once the Axxis HS Digital Label Finisher is webbed, a test cut should be performed to ensure the

proper cut depth. The labels should peel out with ease without cutting into the liner.

1. Install knife holder and blade into cutting head. (See section 1.4.2 for instructions)

1. Press load button (“ready-to-cut” status).

2. Press and hold the down arrow button to bring out cutter carriage above the material.

3. Press the “TC” button on the front control panel to perform a test cut.

4. Weed the test cut and check for a clean cut without scoring of the liner.

5. If the cut is not deep enough, increase the force using the force pad and/or expose more blade.

If liner is cut, then reduce force and/or expose less blade. It is better to have the least amount of

blade exposed to cut job and apply more force.

6. Once desired cutting force is achieved line up the red SmartMark LED on the cutting head with

the upper right hand corner (ush with top) of the SmartMark.

1.2.6.3 Test Cut on Axxis HS Digital Label Finisher