Specifications
20
1.2.6.2 Webbing test for Axxis HS Digital Label Finisher
This quick test will help ensure that the system is webbed as straight as possible.
1. Raise pinch wheels on cutting platform.
2. Make sure web roller guides (black thin donuts) are loose. If preset from previous run with
same roll size, try webbing test rst then adjust as necessary.
3. Press Load Button on front panel of Axxis HS Digital Label Finisher, the input accumulator will
lower to bottom and the output accumulator will rise to the top. Once accumulators stop moving
press the Load button a second time to disarm the system. Now the red LED next to Load on the
front panel of the cutter is off.
4. With the input (left) acumulator down & output (right) acumulator up – move up and down
by hand to check tracking. Grab each accumulator as shown in A, then move accumulators
to opposite postion shown in C. As you do this watch the paper at B and notice as the output
accumulator goes to bottom if the web moves in either direction.
a) If material runs straight on ruler at B, with little to no operator to gear side movement
then the material is webbed straight.
b) If material moved to operator side then move material towards operator side. To adjust
hold end of material before releasing output nip black lock lever, this way the accumulator
will not pull material backwards and drop to bottom. Now adjust material to operator
side desired amount to square. Repeat webbing test.
7. Feed media back up and over cutting bed.
8. Feed media under output accumulator & up through output nip. Conrm media is straight & lock
down the output nip black lever.
9. Verify roll is square with all loops so far.
A. B. C.