Specifications

19
1.2.6 Webbing the Axxis HS Digital Label Finisher
To web the Axxis HS Digital Label Finisher follow the steps below:
1. Power on nisher.
2. The 4 web roller guides (black thin donuts) on accumulator
arms are factory set for 8.5” material. If using a different sized
material, loosen the front donuts only.
3. Load label roll on to mandrel & center to the black rubber
lamination roller (SmartMark towards the gear side).
4. Feed label roll through laminate roller, through nip roller
(make sure black lever is up at 12 o’clock) & back onto itself
to check if square. See image to the right for an example.
5. Once the roll is conrmed square, lock down the nip roller by
rotating the black lever to the 6 o’clock position. This will hold the
material in place.
1.2.6.1 Webbing the Laminate on the Axxis HS Digital Label Finisher
1. Load and center laminate onto upper left mandrel (sticky side up).
2. Pull down laminate over label roll & square with label roll
3. Fold over 1”+ of laminate onto itself as a leader, this way it will not stick to the material when
you pass it through the lamination roller.
4. Feed laminate through (under) laminate roller, verify the laminate is square to printed roll,
rotate black lever counter clockwise to lower laminate roller.
5. Feed 4-5’ of material to web the rest of the system, while doing this you can also smooth out
any wrinkles in the laminate. Do this by:
a) Press F2 button to start feeding material.
b) While material is feeding, open & close laminate roller handle a couple of times to help
square laminate to label roll and allow laminate to nd it’s true web path. (adjust
laminate roll position on mandrel if necessary)
c) Press F2 button to stop input nip roller from feeding.
6. Feed media under input acumulator.