Specifications

13
Thegurebelowshowshowtheelementsofthelabellelookswiththedie-lineandregistration
mark added.
NOTE:Die-linesarecreatedusing“noll”strokelines.Itdoesnotmatterwhatthestrokeweight
of the line is.
8.Oncethedie-linehasbeenputinthele,centerthelabelartworkandthecutlines(die-line)
within the center of the art board.
9. Create a cross-hair to position the square as follows:
a)DisplaytheAirulers(Viewmenu,then“showrulers”)
b) Click on the vertical ruler and drag it to the furthest cut line on the right side of the image.
c)Clickonthehorizontalruleranddragittothehighestcutlineonthetopsideofthe 
 image.Noteitslocationandthenmoveitupanother¼”.
10. Click and drag the rectangle to align its left edge with the vertical guide and its bottom edge
withthehorizontalguide.
Thegurebelowshowstheplacementoftheregistrationmarkwiththeverticalandhorizontal
ruler guides.