Owner`s manual

|J_ETT_IIIEr.
Dolby Digital or DTS Tile connected component is not set to Make an appropriate setting follo'_,ing tile operating --
sources cannot be output Dolby Digital or DTS digital instructions Ibr your component.
played. (Dolby Digital signals.
or DTS indicator in
the front panel Audio input jack select is set to Set Audio input jack select to "AUTO". 34
display does not light "ANALOG".
up.)
A humming sound is Incorrect cable conuections. Connect the audio cables firmly. If the problem --
heard, persists, the cables may be detective.
The volume level You are attempting to set the volume level Adjust "MAX VOL." setting. 67
cannot be increased, higher than the maximum vohnne level.
or the sound is
distorted. Tile compouent connected to tile AUDIO Turn on tile power of tile compouent. --
OUT (REC) jacks of this unit is turned
off.
The sound effect It is not possible to record the sound effect This is not malfimction.
cannot be recorded, with a recording component.
A source cannot be The source component is not connected to Connect the source component to the analog AUDIO 14, 18
recorded by an the analog AUDIO IN jacks of this unit. IN jacks.
analog component
connected to the
AUDIO OUT (REC)
jacks.
The sound field
parameters and some
other settings of this
unit cannot be
changed.
"MEMORY GUARD" in "OPTION
MENU" is set to "ON".
Set "MEMORY GUARD" to "OFF". 70
This unit does not The internal microcomputer has been Disconnect the power cable from the AC wall outlet --
operate properly, frozen by an external electric shock (such and then plug it in again after about 30 seconds.
as lightning or excessive static electricity)
or by a power supply with low voltage.
No sound is heard The HDMI component does not accept the Convert the multi-channel audio signals to the --
from the connected multi-channel audio signals. 2-channel audio signals at the source component such
HDMI component, as a DVD player.
"CHECK SP WIRES" Speaker cables are short-circuited. Make sure all speaker cables are connected correctly. 11
appears in the front
panel display.
There is noise This unit is too close to tile digital or Move this unit further away from such equipment. --
interference from high-frequency equipment.
digital or radio
frequency equipment.
The picture is The video source uses scrambled or This in not malfuuction.
disturbed, encoded signals to prevent dubbing.
This unit suddenly The internal temperature is too high and Wait about 1 hour for this unit to cool down and then --
enters the standby the overheat protection circuitry has been turn it back on.
mode. activated.
80 En