Owner`s manual

The sound suddenly
goes off.
The protection circuitry has been activated
because of a short circuit, etc.
Check that the impedance setting is correct.
Check that the speaker wires are not touching each
other and then turn this unit back on.
21
The sleep timer has turned off this unit. Turn on this unit, and play the source again.
The sound is muted. Press _MUTE or @VOLUME +/- to resume audio 35
output.
Sound is heard from Incorrect cable connections. Connect the cables properly. If the problem persists, 11-18
the speaker on one the cables may be defective.
side only.
Incorrect settings in "SP LEVEL". Adjust the "SP LEVEL" settings. 41
Only the center When playing a monaural source with a This is not malfimction.
speaker outputs CINEMA DSP program, the source signal
substantial sound, is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound is heard "CENTER SP" in "SPEAKER SET" is set Set "CENTER SP" to "SML" or "LRG". 63
from the center to "NONE".
speaker.
Some sound field programs do not output Try another sound field program. 38
sounds from the center speaker.
No sound is heard "SUR. L/R SP" in "SPEAKER SET" is Set "SUR. L/R SP" to "SML" or "LRG". 64
from the surround set to "NONE".
speakers.
This unit is in the "STRAIGHT" mode Press @STRAIGHT so that "STRAIGHT" 39
and a monaural source is being played disappears from the front panel display.
back.
No sound from the "FRONT B" in "SPEAKER SET" is set to Set "FRONT B" to "FRONT". 63
center, surround "ZONE B".
speakers when the
FRONT B speakers
are activated.
No sound is heard "LFE/BASS OUT" in "SPEAKER SET" Set "LFE/BASS OUT" to "SWFR" or "BOTH". 64
from the subwoofer, is set to "FRNT" when a Dolby Digital or
DTS signal is being played.
"LFE/BASS OUT" in "SPEAKER SET" Set "LFE/BASS OUT" to "SWFR" or "BOTH". 64
is set to "SWFR" or "FRNT" when a
2-channel source is being played.
The source does not contain This is not malfimction.
low-frequency bass signals.
79 En