Owner`s manual

'IqIIIFP'IIIqlF
Caution
If you are to use 6 ohm speakers, set "SP IMR" to
"6f_ MIN" as follows BEFORE using this unit.
1 Press @STANDBY/ON on the front panel to
set this unit to the standby mode.
Refer to the right column for details.
2 Press and hold @TONE CONTROL and
then press @STANDBY/ON to turn on this
unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
• Turning on this unit
Press @STANDBY/ON (or @POWER) to turn
on this unit.
Whileholding
TONE CONTROL down
% ,.
When you turn on this unit, there will be a 4 to 5-second delay
before this unit call reproduce sound.
• Set this unit to the standby mode
Press @STANDBY/ON (or @STANDBY) to set
this unit to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
Press @PROGRAM <1/I> to select "SP
IMP,".
"SP IMP." and the current speaker impedance setting
("8_ MIN") appear in the front panel display.
4 Press @STRAIGHT repeatedly to select
"6_ MIN".
5 Press @STANDBY/ON to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this unit.
/
21 En