Quick Start Guide

REV. 5/6/2019 INSTXSVI-6524-BT

CAN connections to the vehicle:

• Disconnect the 2-pin connector from the XSVI-6524-BT harness.

• Connect the

2-pin CAN harness to the XSVI-6524-BT harness.

• Route the harness to the vehicles OBD port located under the driver’s side dash.

Option 1

• Connect the White/Red wire to the CAN-HI wire. (Figure A)

• Connect the White/Green wire to the CAN-LO wire. (Figure A)

Option 2

• Use part number AX-IL-OBD2 to “T” into the OBD port.

12-pin pre-wired ASWC-1 harness:

This harness is to be used along with the ASWC-1 (sold separately) to retain steering wheel

audio controls. If the ASWC-1 is not being used, disregard this harness. If it is to be used,

please refer to the ASWC-1 instructions for radio connections and programming. Disregard

the harness that comes with the ASWC-1.

With the key in the off position:

1. Connect the

XSVI-6524-BT harness

to the

XSVI-6524-BT interface

, and then to the

wiring harness in the vehicle.

2. If an ASWC-1 (sold separately) will be used, do not connect it until the XSVI-6524-BT is

programmed and fully functional.

CONNECTIONS (CONT.) I NSTALL ATI O N

(Figure A)

Attention!

If the interface ever loses power, the following steps will need to be performed

again. Please ensure that the owner of the vehicle knows this.

1. Turn the key (or push-to-start button) to the ignition position and wait until the radio

comes on.

Note: If the radio doesn’t not come on within 60 seconds, turn the key to the off

position, disconnect the interface, check all connections, reconnect the interface, and

then try again.

2. Turn the key (or push-to-start button) to the off position, then open and close the

driver’s door.

3. Wait 5 minutes for the vehicle to fully go to sleep.

4. Start the vehicle, then test all functions of the installation for proper operation.

PROGRAMMING