User Manual

REV. 10/31/2018 INSTTYTO-03

With the key in the off position:

1. Connect the

16-pin harness with stripped leads

, and the

TYTO-03 harness

, into the

TYTO-03

interface

2. Connect the

backup camera harness

, and the

TYTO-03 harness

, to the wiring harness in the

vehicle.

3. If an ASWC-1 (sold separately) will be used, do not connect it until the TYTO-03 is

programmed and fully functional.

Attention! If the interface ever loses power, the following steps will need to be performed again.

Please ensure that the owner of the vehicle knows this.

1. Turn the key (or push-to-start button) to the ignition position and wait until the radio comes

on.

Note: If the radio doesn’t not come on within 60 seconds, turn the key to the off position,

disconnect the interface, check all connections, reconnect the interface, and then try again.

2. Cycle the key off, then back on. If the driver’s door is closed, open and close the door.

3. Test all functions of the installation for proper operation, before reassembling the dash.

Note: To use fade, ensure that the radio is turned up 3/4 of the way. Also note that the fader

will not entirely cut out the speakers.

With the vehicle and radio turned on, turn the volume up 3/4 of the way.

With a small ﬂat-blade screwdriver, adjust the potentiometer clockwise to raise the audio

level; counterclockwise to lower the audio level.

Once at a desired level, audio level adjustment is complete.

I NSTALL ATI O N

PROGRAMMING

AUDIO LEVEL ADJUSTMENT