User Manual

2
CONNECTIONS
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Blue/White wire to the amplifier turn on wire. This wire must be connected to
hear sound from the factory amplifier.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• Tape off and disregard the following (6) wires, they will not be used in this application:
Blue/Pink, Brown, Green/Purple, Light Green, Orange/White, Red
From the TYTO-03 harness to the aftermarket radio:
• Connect the Black wire to the ground wire. There will also be a ground wire from the backup
camera harness to connect as well.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Green/Purple wire to the reverse wire, and also to the Blue/White wire from
the AX-CAM6V.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Red and White RCA jacks to the audio AUX-IN jacks from the aftermarket radio.
12-pin ASWC-1 harness & 3.5mm jack:
The 12-pin ASWC-1 harness & 3.5mm jack is to be used with the ASWC-1 (sold separately)
to retain steering wheel audio controls. If the ASWC-1 is not being used, disregard this
harness. If it is to be used, please refer to the ASWC-1 instructions for radio connections and
programming. Disregard the harness that comes with the ASWC-1.
Backup camera harness:
• Connect the Black wire labeled “CAMERA GROUND”, to the ground from the TYTO-03
harness , and also to the Black wire from the AX-CAM6V.
• Connect the Red wire labeled “CAMERA POWER 6V”, to the Blue/Red wire from the AX-
CAM6V.
• Connect the Yellow RCA jack labeled “BACKUP CAMERA”, to the radios backup camera input.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Light Green wire to the radios parking brake wire.