User Manual

ManualsBrandsAXXESS ManualsCar Electronics & GPSWiring Harness for 2018 and Later Toyota Camry Vehicles - Black

TYTO-03

INSTALLATION INSTRUCTIONS

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Crimping tool and connectors, or solder gun,

solder, and heat shrink • Tape • Wire cutter

• Zip ties • Small ﬂat-blade screwdriver

TABLE OF CONTENTS

Connections ............................................................2

Installation .............................................................3

Programming .........................................................3

Audio Level Adjustment ........................................3

Toyota Camry Ampliﬁer Interface

2018-up

• Provides NAV outputs (parking

brake, reverse, speed sense)

• Pre-wired ASWC-1 harness

(ASWC-1 sold separately)

• Retains the factory AUX-IN jack

• Retains the factory backup

camera

• Includes an AX-CAM6V 12-to-

6V step-down for the factory

camera

• Designed for ampliﬁed models

• Retains balance and fade

• Micro-B USB updatable

• TYTO-03 interface

• TYTO-03 harness

• 16-pin harness with stripped leads

• AX-CAM6V

• Backup camera harness

Visit AxxessInterfaces.com for more detailed information about the product and up-to-date

vehicle speciﬁc applications

Summary of content (4 pages)

PAGE 1
TYTO-03 I N S TA L L AT I O N I N S T R U C T I O N S Toyota Camry Amplifier Interface 2018-up Visit AxxessInterfaces.
PAGE 2
CONNECTIONS From the 16-pin harness with stripped leads to the aftermarket radio: • Connect the Blue/White wire to the amplifier turn on wire. This wire must be connected to hear sound from the factory amplifier. • Connect the Gray wire to the right front positive speaker output. • Connect the Gray/Black wire to the right front negative speaker output. • Connect the White wire to the left front positive speaker output. • Connect the White/Black wire to the left front negative speaker output.
PAGE 3
INSTALLATION With the key in the off position: 1. Connect the 16-pin harness with stripped leads, and the TYTO-03 harness, into the TYTO-03 interface. 2. Connect the backup camera harness, and the TYTO-03 harness, to the wiring harness in the vehicle. AUDIO LEVEL ADJUSTMENT 1. With the vehicle and radio turned on, turn the volume up 3/4 of the way. 2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio level; counterclockwise to lower the audio level. 3.
PAGE 4
TYTO-03 I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.