User Manual

REV. 12/29/2017 INSTTYTO-01

From the 20-pin harness, to the aftermarket radio:

• Connect the Yellow wire to the 12-volt battery/memory wire.

• Connect the Black wire to the ground wire.

• Connect the Red wire to the accessory/ignition wire.

• Connect the Orange wire to the illumination wire.

Note:

If the aftermarket radio does not have an illumination wire, tape up and disregard the

Orange wire.

• Connect the 14-pin harness to the TYTO-01.

• With all connections completed to the aftermarket radio, plug the 20-pin harness into the

vehicles wiring harness.

• Reconnect the negative battery terminal.

• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again to test the

radio.

• Turn the ignition on if not already, and then turn the radio on to verify that the radio

works. Check balance and fader controls for proper operation.

• To adjust the overall volume of your audio system, rotate the potentiometer which is

located on the 16-pin side of the interface clockwise.

CONNECTIONS TO BE MADE INSTALLING THE TYTO-01

TESTING THE TYTO-01