Quick Start Guide

4
PROGRAMMING
Open the driver’s door, and keep open during the programming process.
Cycle the ignition on.
Connect the AXTC-FD1 harness to the AXTC-FD1 interface, and then to
the wiring harness in the vehicle.
For (auto*) vehicles: Do not touch the steering wheel controls, the
interface will auto program.
For (tap*) vehicles: Locate the Volume Up button on the steering
wheel. Program the interface by tapping the Volume Up button at a
heartbeat pace until the LED light stops flashing.
*Refer to the application list on page 2
The LED light will flash Green & Red while the interface programs the
radio to the steering wheel controls. Once programmed, the LED light
will go out, then produce a pattern which will identify the radio type
installed.
The LED light will go out, then once again quickly flash Green & Red
while the interface programs itself to the vehicle. Once programmed,
the LED light will go out again, then turn solid Green.
Cycle the ignition off, then back on.
Test all functions of the installation for proper operation.
1.
2.
3.
4.
5.
6.
7.
8.
Green & Red LED
Green or Red LED
Green & Red LED
Green LED
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
VOL
+
Do Not Touch
VOL
+
Tap Volume Up