Quick Start Guide

5
REV. 5/7/2019 INSTAXTC-CH013
PROGRAMMING
Open the driver’s door, and keep open during the programming process.
Cycle the ignition on.
Connect the appropriate LD-SWCX harness to the AXTC-CH013 interface,
and then to the wiring harness in the vehicle.
Locate the Volume Up button behind the steering wheel on the right
hand side. Program the interface by tapping the Volume Up button at a
heartbeat pace until the LED light stops flashing.
The LED light will flash Green & Red while the interface programs the
radio to the steering wheel controls. Once programmed, the LED light
will go out, then produce a pattern which will identify the radio type
installed.
The LED light will go out, then once again quickly flash Green & Red
while the interface programs itself to the vehicle. Once programmed,
the LED light will go out again, then turn solid Green.
Cycle the ignition off, then back on.
Test all funtions of the installation for proper operation.
1.
2.
3.
4.
5.
6.
7.
8.
Green & Red LED
Green LED
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
Green & Red LED
Green or Red LED