Quick Start Guide

3
REV. 5/11/2018 INSTAX-VL90032
With the key in the off position:
• Locate the factory amplifier under the passenger seat .
• Extend the wire harness with the Gray and Green
connectors to this point.
• Unplug the connectors from the amplifier, then
connect the Gray and Green connectors to the
harnesses unplugged from the amplifier. (Figure A)
Note: The factory Green connector in the middle
will not be used in this application. It can left
plugged in or unplugged.
• Locate the Green 10-pin connector behind the
climate control panel. (Figure B)
• Unplug the connector, then plug in the Green male
10-pin connector from the AX-VL90032 harness into
the climate control panel.
• Connect the factory male 10-pin connector, into the
Green female 10-pin connector from the AX-VL90032
harness.
• Connect the AX-VL90032 harness to the
AX-VL90032 interface.
• Connect the ASWC-1 harness to the ASWC-1 interface,
and then to the AX-VL90032 interface.
INSTALLING THE AX-VL90032 INTERFACE
(Figure A) (Figure B)