Quick Start Guide

CONNECTIONS TO BE MADE INSTALLING THE INTERFACE

From the aftermarket radio to the AX-PO904 harness:

• Connect the Black wire to the ground wire.

• Connect the Yellow wire to the battery wire.

• Connect the Red wire to the accessory wire.

• If the aftermarket radio has an illumination wire, connect the Orange wire to it.

• Connect the Blue/White wire to the amp turn-on wire.

The following (3) wires are only for multimedia/navigation radios that require these wires.

• Connect the Blue/Pink wire to the VSS/speed sense wire.

• Connect the Green/Purple wire to the reverse wire.

• Connect the Light Green wire to the parking brake wire.

• Tape off and disregard the following (8) wires, they will not be used in this application:

Gray, Gray/Black, Green, Green/Black, Purple, Purple/Black, White, White/Black

• Connect the Red and White RCA jacks to the front ampliﬁer output jacks of the aftermarket radio.

With the key in the off position:

• Connect the AX-PO904 harness to the AX-PO904 interface.

• Connect the AX-PO904 harness to the AX-PO904 ampliﬁer interface.

• Remove the dust cover from ﬁber optic port in the AX-PO904 ampliﬁer interface.

• Connect the factory ﬁber optic cable into the AX-PO904 ampliﬁer interface.

• Connect the AX-PO904 harness to the wiring harness in the vehicle.