User Manual

Installation instructions for part AX-MTR
REV. 12/22/2016 INSTAX-MTR
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
®
axxessinterfaces.com
•
metraonline.com
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
Axxess Integrate
®
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
Programming the AX-MTR with
a Feature Number
(Continued)
End of timer: The LED will flash rapidly 4 times indicating that the timer is finish recording.
Note: Repeat step 3 if more than one timer has to be recorded, otherwise go to step 4.
Example 1: If you want 36 seconds for a timer, ‘Pulse’ the trigger wire one time. The LED will flash
rapidly 1 time, wait 3 seconds and 0 minutes will be recorded. The LED will flash rapidly 2 times,
‘Pulse’ the trigger wire 3 times, after 3 seconds the LED will flash 3 times indicating 3 was recorded
for the tens place. The LED will flash rapidly 3 times, ‘Pulse’ the trigger wire 6 times and after 3
seconds the LED will flash 6 times indicating 6 was recorded for the ones place
.
Example 2: If you want 2 minutes and 25 seconds for a timer, ‘Pulse’ the trigger wire one time.
The LED will flash rapidly 1 time, ‘Pulse’ the trigger wire 2 times, after 3 seconds the LED will flash
2 times, indicating 2 was recorded for the minutes place. The LED will flash rapidly 2 times, ‘Pulse’
the trigger wire 2 times, after 3 seconds the LED will flash 2 times indicating 2 was recorded
for the tens place. The LED will flash rapidly three times, ‘Pulse’ the trigger wire 5 times, after 3
seconds the LED will flash 5 times indicating 5 was recorded for seconds in the ones place .
Note: The maximum time that can be set is 4 minutes and 15 seconds. If you go beyond the
maximum time, the AX-MTR will automatically use 4 minutes and 15 seconds as a time. In
Feature# 10, if you did not program for any timers, then the ‘Timer’ section will automatically be
skipped.
4.
After all options and/or timers are programmed; the LED will flash rapidly for 3 seconds, indicating
that programming is finished. Slide the switch to the OFF position. If you make a mistake during
programming, you will need to start over from step 1.
5. Return to the previous section to finish wiring the AX-MTR.