Installation Guide

3
REV. 11/8/2018 INSTAX-HYKIA3-SWC
CONNECTIONS (CONT.)
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
Connect the Blue/Pink wire to the VSS/speed sense wire.
If the factory AUX-IN jack is desired to be retained, connect the Red & White RCA jacks to the
audio AUX-IN jacks.
Connect the Yellow RCA jack to the backup camera input.
For models equipped
without
a factory amplifier:
Connect the Green wire to the left rear positive speaker output.
Connect the Green/Black wire to the left rear negative speaker output.
Connect the Purple wire to the right rear positive speaker output.
Connect the Purple/Black wire to the right rear negative output.
Disregard the 14-pin connector, it will not be used in this application.
For models equipped
with
a factory amplifier:
Connect the AX-HYKIA-SPDIF (sold separately) to the 14-pin connector.
Tape off and disregard the following (4) wires, they will not be used in this application:
Green, Green/Black, Purple, Purple/Black
3.5mm jack steering wheel control retention:
The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
For the radios listed below:
Connect the
female 3.5mm connector with stripped leads
, to the male
3.5mm SWC jack from the
AX-HYKIA3-SWC harness
.
Any remaining wires tape off and disregard
.
Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White
wire from the connector. Then connect the remaining steering wheel control wire,
normally Brown/White, to the Brown wire from the connector.
Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow
wire to the Brown wire.
Note: If the Kenwood radio auto detects as a JVC, manually set the radio type to
Kenwood. See the instructions under Changing Radio Type.
XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack to the AX-SWC-PARROT (sold
separately). Then connect the 4-pin connector from the AX-SWC-PARROT to the radio
.
Note: The radio must be updated to rev. 2.1.4 or higher software.
Universal “2 or 3 wire” radio: Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the Brown wire from the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire
from the connector. If the radio comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information
.
For all other radios: Connect the 3.5mm jack from the
AX-HYKIA3-SWC harness
to the jack
on the radio designated for an external steering wheel control interface. Please refer to the
aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.