Installation Guide
2
CONNECTIONSAPPLICATIONS
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If the vehicle comes equipped with a factory amplifier, connect the Blue/White wire to the
amp turn-on wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green/Purple wire to the reverse wire, and also to the Blue/White wire from
the AX-CAM6V.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (8) wires, they will not be used in this application:
Blue/Pink, Blue/White*, Brown, Green, Green/Black, Orange/White, Purple, Purple/Black
* Non-amplified models only
From the AX-HYKIA3-SWC harness to the aftermarket radio:
• Connect the Black wire, the Black wire labeled “Camera Ground”, and also the Black wire
from the AX-CAM6V, to the ground wire.
•
Connect the Red wire labeled “Camera Power 6V”, to the Blue/Red wire from the AX-CAM6V
.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
Hyundai
Accent (1) 2018-up
Elantra (2) 2019-up
Elantra (4) 2017-2018
Elantra GT 2018-up
Ioniq (3) 2018-up
Kona 2018-up
Santa Fe 2019-up
Santa Fe XL 2019-up
Sonata 2018-up
Sonata (3) 2017
Kia
Forte 2019-up
Forte / Forte 5 (4) 2017-2018
Optima (5) 2019
Rio / Rio 5 (1) 2018
Sedona (4) 2017-2018
Sorento 2019
Soul (4) 2017-2019
(1) With Android Auto / Apple CarPlay radio
(2) With Android Auto / Apple CarPlay radio or NAV
(3) Without NAV
(4) With Android Auto / Apple CarPlay radio, without NAV
(5) With manual climate control
Continued on the next page