User Manual

2
CONNECTIONS TO BE MADE
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If the vehicle comes equipped with a factory amplifier, connect the Blue/White wire to the
amp turn-on wire.
• If the aftermarket radio has a mute wire, connect the Brown wire to it. If the mute wire is
not connected, the radio will turn off when BlueLink is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
The following (2) wires are only for a multimedia/navigation radio that requires these wires.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (7) wires, they will not be used in this application:
Blue/Pink, Blue/White*, Green, Green/Black, Orange/White, Purple, Purple/Black
* Non-amplified models
From the AX-HYKIA1-SWC harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Red and White RCA jacks to the audio AUX-IN jacks of the aftermarket radio.
For models equipped without a factory amplifier only:
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
For models equipped with a factory amplifier only:
• Connect the AX-HYKIA-SPDIF (sold separately) to the 14-pin connector.
• Cut the front speaker wires away from the main 18-pin connector:
Gray, Gray/Black, White, White/Black
Continued on the next page