User Manual

4
INSTALLING THE AX-AM-GM91
• Remove the 20-pin connector from the radio module*, then connect the male plug from the
20-pin “T” harness into the radio module. (Figure A)
* Refer to the Human Machine Interface (HMI) and radio module location list.
• Connect the factory male factory connector into the female plug from the 20-pin “T” harness .
• Connect the
20-pin “T” harness into the AX-AM-GM91 interface.
• Connect the 2-pin connector from the 20-pin “T” harness to the 2-pin connector from the 16-
pin “T” harness .
• Remove the 16-pin connector from the Human Machine Interface (HMI) module*, then connect
the male plug from the 16-pin “T” harness into the HMI module. (Figure B)
* Refer to the Human Machine Interface (HMI) and radio module location list.
• Connect the factory male factory connector into the female plug from the 16-pin “T” harness .
• Connect the
16-pin “T” harness into the AX-AM-GM91 interface.
• If adding an HDMI input to the factory radio, connect the
3.5mm extension cable to the 16-pin
“T” harness , and then to the vehicles 3.5mm AUX-IN jack.
• Remove the USB connector from the Blue receptacle in the HMI module, then connect it to the
LVDS (video) to USB cable .
• Connect the
LVDS (video) to USB cable into the AX-AM-GM91 interface.
• Connect the
6-pin to USB cable into the HMI module, and then into the AX-GM91 interface.
• Connect the 10-pin harness with RCA jacks into the AX-AM-GM91 interface.
Continued on the next page
(Figure A)
(Figure B)