User Manual

ManualsBrandsAXXESS ManualsCar Electronics & GPSAXXESS - Audio Interface Adapter - Black

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

AX-AM-GM91

INSTALLATION INSTRUCTIONS

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Wire cutter • Crimp tool • Solder gun • Tape

• Connectors (example: butt-connectors, bell

caps, etc.)

TABLE OF CONTENTS

Connections to be made .......................................2

Conﬁguring the AX-AM-GM91 ...............................3

Installing the AX-AM-GM91 ................................4-5

User guide ..............................................................6

GM HDMI and Camera Interface 2013-up*

• Provides front and rear camera inputs to the factory radio

• Provides an HDMI input to the factory radio

• Micro “B” USB updatable

• AX-AM-GM91 interface

• 20-pin “T” harness

• 16-pin “T” harness

• 6-pin to USB cable

• LVDS (video) to USB cable

• 10-pin harness with RCA jacks

• 3.5mm extension cable

*Visit AxxessInterfaces.com for up-to-date vehicle speciﬁc applications.

APPLICATIONS

See inside front cover

Summary of content (8 pages)

PAGE 1
AX-AM-GM91 I N S TA L L AT I O N I N S T R U C T I O N S GM HDMI and Camera Interface 2013-up* *Visit AxxessInterfaces.com for up-to-date vehicle specific applications. INTERFACE FEATURES • Provides front and rear camera inputs to the factory radio • Provides an HDMI input to the factory radio • Micro “B” USB updatable TOOLS REQUIRED • Wire cutter • Crimp tool • Solder gun • Tape • Connectors (example: butt-connectors, bell caps, etc.
PAGE 2
APPLICATIONS (1) For models with an 8-inch CUE Infotainment system (2) For models with an 8-inch MyLink radio (3) For models with an 8-inch IntelliLink Radio 2 LVDS OUT LVDS IN (Connections Diagram) HDMI IN AV IN POWER CAM GROUND 2017-up 2015-up 2014-up 2017-up 2015-up 2013-2017 2017-up REAR CAM PWR GMC (3) Acadia/Denali Canyon/Denali Sierra 1500/2500/3500/Denali Terrain Yukon/Yukon XL/Denali OPEL VAUXHALL (2) Insignia Insignia Grand Sport • If installing a front/rear camera, connect the Blac
PAGE 3
CONFIGURING THE AX-AM-GM91 Dip switch settings Remove the access door located on the top of the AX-AM-GM91 interface to access the dip switches. Dip 1 If the vehicle is equipped with a factory backup camera: On: Yes Off: No Dip 2 If the vehicle has an aftermarket front camera: On: Yes Off: No Dip 3 If the vehicle has an aftermarket backup camera: On: Yes Off: No Dips 4 & 5 For all applications: Dip 4: Off Dip 5: Off REV.
PAGE 4
INSTALLING THE AX-AM-GM91 • Remove the 20-pin connector from the radio module*, then connect the male plug from the 20-pin “T” harness into the radio module. (Figure A) * Refer to the Human Machine Interface (HMI) and radio module location list. • Connect the factory male factory connector into the female plug from the 20-pin “T” harness. • Connect the 20-pin “T” harness into the AX-AM-GM91 interface.
PAGE 5
INSTALLING THE AX-AM-GM91 (CONT) Human Machine Interface (HMI) and radio module location CADILLAC ATS CTS CTS (coupe) Escalade SRX XTS 2014-up 2014-up 2014-up 2015-up 2013-up 2013-up HMI: Behind glovebox HMI: Under passenger side dash HMI: Under passenger side dash HMI: Behind glovebox HMI: Behind glovebox HMI: Right of glovebox Radio: Behind radio Radio: Right of glovebox Radio: Right of glovebox Radio: Behind radio Radio: Behind radio Radio: Right of glovebox CHEVROLET Colorado Impala Malibu Silvera
PAGE 6
USER GUIDE Button Configuration • The factory “HOME KEY” button will be used to operate the AX-AM-GM91. HDMI access • Select AUX-IN as a source from the factory radio. • Press hold the “HOME KEY” button for 2 seconds to switch between the factory screen and the AX-AM-GM91 screen. • Press the top right corner of the screen to disable the video-in-motion warning message. Front camera access • Ensure dip switch 2 is selected to “ON”. • Press the top right corner of the screen to activate the front camera.
PAGE 7
REV.
PAGE 8
AX-AM-GM91 I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.