Installation manual

Section 1: Installation
Installing the ASWC
1) ConnecttheBlackwireoftheASWCtoground.Youmayusethe
samegroundingpointastheaftermarketradio.
2) ConnecttheRedwireoftheASWCtoa12-voltaccessorywire,one
thatturns“on”and“off”withtheignitionkey.
3) LocatethecorrectSWCwire(s)inthevehicle’sradioprimaryor
secondaryharnessasdescribedinthevehicleinformationsheet
foundontheAxxesswebsite.Connectthecorrectwirecolor(s)from
theASWCtothesteeringwheelcontrolwire(s)inthevehicle.
Note: Metra recommends that the wire(s) are soldered for the
best and most secure connection. T-Taps or scotch locks are not
recommended due to the higher chance of an intermitted connection
or change in resistive values.