Installation manual

8
TheASWC-1canbeprogrammedtwodifferentways.Itcanauto
programitselfthroughAutoDetectMode,oritcanbemanually
programmed(pp.19-21).Thefollowing,whichisrecommended,isfor
autoprogramming.
Auto Detect Mode: Overview
TheASWC-1hastheabilitytoautodetectselectvehiclesandwhat
aftermarketradioitisconnectedto.The“ASWC-1VehicleInstructions”,
foundatwww.axxessinterfaces.com,willindicateifyourvehiclewillauto
detectandwhataction,ifany,isrequiredforthisprocesstotakeplace.
Fortheautodetectfeaturetoworkthereare(3)possibleactionsthatmust
betaken.Note,onlyoneactionwillberequireddependingonthevehicle:
1. Turntheignitiononandnootheractionisrequired.
--- Or ---
2. Turntheignitionon,pressandholdtheVolume Upbuttononthe
steeringwheel.
--- Or ---
3. Turntheignitionon,andthentaptheVolume Upbuttonrepeatedly
onthesteeringwheel.
Auto Detect Mode: Steps
Note: Please read all Auto Detect Mode steps before beginning.
1) Completeconnectionstothevehicleandtheaftermarketradio.
2)
Turntheignitionon,theLEDwillstartrapidlyflashingRed;which
meanstheASWC-1islookingforthevehicleandtheradio.
Note: If the LED did not start flashing Red rapidly press the reset
button for 3 seconds and then proceed to Step 3.
3) Performactionrequiredforyourparticularvehicle,asnotedinthe
“ASWC-1VehicleInstructions”,downloadfromAxxessinterfaces.com.
ASWC-1 Installation
Programming